For Wacom Cintiq Pro pen displays, when facing the rear of the display, the model number and serial number will be located beneath the left support leg. The model number is on the back of the device, below the Wacom name:. For Intuos4, Intuos5, and Intuos Pro pen tablets, the model number is listed next to the text reading "Model.
For Cintiq 27QHD pen displays, the panel in the center of the back of the display, covering display connections, must be removed to view the model number and serial number.
The display may need to be rotated or removed from the stand to access:. The serial number is located further down, next to the text reading "Serial Number":. For Intuos pen tablets, the cover on the bottom of the tablet must be removed. Once removed you will see where the optional wireless kit can be installed, the spare nibs, as well as the model number and the serial number, beneath the barcode:.
For Wacom Cintiq Pro pen displays, when facing the rear of the display, the model number and serial number will be located beneath the left support leg. The model number is on the back of the device, below the Wacom name:. For Intuos4, Intuos5, and Intuos Pro pen tablets, the model number is listed next to the text reading "Model.
This requires special handling in the application. If you need to capture signatures over Citrix then please see our Citrix Compatibility list. The , and V provided limited screen space so if you need to display a lot of information for the user to read prior to signing then it would probably be better to choose a The STU is primarily aimed at installations where a high degree of security is required in the data transmission between the pad and the PC.
The uses TLS encryption to deliver this. The driver is also required when using any STU signature pad on Windows 8 or 8. On Windows 8 and 8. The driver installation merely configures the USB interface for the STU tablet and can be used in all configurations without any detrimental effect. Download and unzip reg-delete-wacom-usb-cache.
First disconnect the STU device. The utility prompts to allow changes to your device. Download hidinfo-xv2. Installation of an STU tablet.
Colour models require the STU driver Download and unzip the diagnostic to run on 32 or 64 bit Windows. Download and use the tool according to the directions provided by your support engineer. Normally you will need to run the following command in a Dos prompt and email the resulting text file:.
Note: By default the signature software requires exclusive-read-write access to the device to operate successfully. In some installations other applications or installed drivers may access the device in shared mode.
0コメント